8 material differences · fewer than 12
Tractor oneClaas Ares 657 ATZ2005–2007No measured PTO figureTractor twoNew Holland T 6050 Elite2008–2012No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2005–2007; 2008–2012). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Ares 657 ATZ | T 6050 Elite | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 123.2 hp | 123.2 hp | — |
| Engine declared | — | IVECO-NEF 667 TA | — |
| Displacement declared | — | 6.73 L | — |
| Maximum torque declared | 350 lb·ft · 474.9 N·m | 405 lb·ft · 549 N·m | +16% T 6050 Elite |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 27.8 gpm · 105.4 L/min | — |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 11,089 lb · 5,030 kg | 12,434 lb · 5,640 kg | +12% T 6050 Elite |
| Maximum permissible mass declared | 19,401 lb · 8,800 kg | 19,842 lb · 9,000 kg | — |
| Wheelbase declared | 111.0 in · 2,820 mm | 104.4 in · 2,652 mm | +6% Ares 657 ATZ |
| Length declared | 203.1 in · 5,160 mm | 190.0 in · 4,825 mm | +7% Ares 657 ATZ |
| Width declared | 100.4 in · 2,550 mm | 96.5–115.0 in · 2,450–2,922 mm | differs |
| Ground clearance declared | — | 18.1 in · 460 mm | — |
| Fuel tank declared | 264.2 qt · 250 L | 243.0–264.2 qt · 230.0–250.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Ares 657 ATZ sources
- Source: Traktorenlexikon, “Claas Ares 657 ATZ”
- Source: OECD test report 2294, 2005
New Holland T 6050 Elite sources
- Source: Traktorenlexikon, “New Holland T 6050 Elite”