3 material differences · fewer than 12

Tractor oneClaas Ares 617 ATZ2005–2007No measured PTO figureTractor twoSteyr 4110 Expertfrom 2019No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (2005–2007; 2019–2019). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

3 material differences · 4 fields identical or within 5%, which is not counted as material

Claas Ares 617 ATZ and Steyr 4110 Expert, field by field
FieldAres 617 ATZ4110 ExpertGap
Engine
Engine power, claimed claimed108.5 hp109 hp—
Maximum torque declared326 lb·ft · 442.0 N·m——
Transmission
Top speed declared24.9 mph · 40 km/h24.9 mph · 40 km/h—
Hydraulics & hitch
Pump flow declared—29.1 gpm · 110 L/min—
Pressure declared2,901 psi · 200 bar2,901 psi · 200 bar—
Rear PTO speeds declared540/1000 rpm540 rpm / 1000 rpmdiffers
Weight & dimensions
Unladen weight declared11,045 lb · 5,010 kg12,125 lb · 5,500 kg+10% 4110 Expert
Maximum permissible mass declared17,637 lb · 8,000 kg——
Wheelbase declared111.0 in · 2,820 mm98.0 in · 2,490 mm+13% Ares 617 ATZ
Length declared195.9 in · 4,975 mm188.3 in · 4,784 mm—
Width declared—87.7 in · 2,228 mm—
Fuel tank declared264.2 qt · 250 L——

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Claas Ares 617 ATZ sources

Source
  • Source: Traktorenlexikon, “Claas Ares 617 ATZ”
  • Source: OECD test report 2293, 2005

Steyr 4110 Expert sources

Source
  • Source: Traktorenlexikon, “Steyr 4110 Expert”