10 material differences · fewer than 12
Tractor oneCase-Steyr M 9094 a1994–2003No measured PTO figureTractor twoFendt Favorit 509 C1994–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | M 9094 a | Favorit 509 C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.8 hp | 93.2 hp | — |
| Engine declared | Steyr-MWM WD 401.85 | MWM TD 226. B-4 | differs |
| Displacement declared | 4.16 L | 4.16 L | — |
| Maximum torque declared | — | 281 lb·ft · 381 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Dry Fichtel & Sachs double clutch | Wet multi-plate drive clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 12.7 gpm · 48.1 L/min | 26.5 gpm · 100.2 L/min | +108% Favorit 509 C |
| Pressure declared | — | 2,538 psi · 175 bar | — |
| Rear PTO speeds declared | 430/540/1000 rpm | 540 rpm / 750 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,708 lb · 3,950 kg | 10,957 lb · 4,970 kg | +26% Favorit 509 C |
| Maximum permissible mass declared | 14,330 lb · 6,500 kg | — | — |
| Wheelbase declared | 97.7 in · 2,481 mm | 91.9 in · 2,333 mm | +6% M 9094 a |
| Length declared | 165.9 in · 4,215 mm | 164.6 in · 4,180 mm | — |
| Width declared | 85.4 in · 2,170 mm | 84.3 in · 2,140 mm | — |
| Ground clearance declared | 17.3 in · 440 mm | 21.1 in · 536 mm | +22% Favorit 509 C |
| Turning radius, braked declared | 14.1 ft · 4.30 m | 13.1 ft · 4.00 m | +7% M 9094 a |
| Fuel tank declared | 105.7 qt · 100.0 L | 142.7 qt · 135 L | +35% Favorit 509 C |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-Steyr M 9094 a sources
- Source: Traktorenlexikon, “Steyr M 9094 a”
- Source: Traktorenlexikon, “Steyr 9094”
Fendt Favorit 509 C sources
- Source: Traktorenlexikon, “Fendt Favorit 509 C”
- Source: Traktorenlexikon, “Fendt Farmer 308”