Case-Steyr 9115 a or Deutz-Fahr AgroStar 6.28?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 9115 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Case-Steyr 9115 a suits loader and hydraulic implement work better on this data: 53% (29.3 L/min / 7.7 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 9115 a | AgroStar 6.28 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 84.6 kW (113.5 hp)Traktorenlexikon, “Steyr 9115” | 84.6 kW (113.5 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | Not comparableNot comparable on power at the PTO shaft: the 9115 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 9115 a and the AgroStar 6.28. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 9115 a and the AgroStar 6.28. |
| Which pumps more oil for implements? | 84.3 L/min (22.3 gpm)Traktorenlexikon, “Steyr 9115” | 55.0 L/min (14.5 gpm)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | AheadThe Case-Steyr 9115 a has 53% more hydraulic flow (29.3 L/min / 7.7 gpm) than the Deutz-Fahr AgroStar 6.28 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 6,900 kg (15,212 lb)Traktorenlexikon, “Steyr 9115” | 6,500 kg (14,330 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | Not comparableNot comparable on three-point lift: the 9115 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 9115”); the AgroStar 6.28: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 5,245 kg (11,563 lb)Traktorenlexikon, “Steyr 9115” | 4,640 kg (10,229 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | Ahead (a fact, not an advantage)The Case-Steyr 9115 a is 13% heavier (605 kg / 1,334 lb) than the Deutz-Fahr AgroStar 6.28 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 9,000 kg (19,842 lb)Traktorenlexikon, “Steyr 9115” | 8,500 kg (18,739 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which has the wider choice of gears? | 20 to 24Traktorenlexikon, “Steyr 9115” | 40 to 48Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | AheadThe Deutz-Fahr AgroStar 6.28 has 67% more forward gears (16 gears) than the Case-Steyr 9115 a (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | YesTraktorenlexikon, “Deutz-Fahr AgroStar 6.28” | No figureNo call on a creeper range: not stated for the 9115 a. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “Steyr 9115” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540 rpm / 1000 rpmTraktorenlexikon, “Steyr 9115” | 540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 6.28” | AheadThe Deutz-Fahr AgroStar 6.28 offers 750 rpm at the PTO, which the Case-Steyr 9115 a does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Steyr 9115” | independentTraktorenlexikon, “Deutz-Fahr AgroStar 6.28” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Steyr 9115” | 4WDTraktorenlexikon, “Deutz-Fahr AgroStar 6.28” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1995–2003 | 1993–1995 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-Steyr 9115 a has 53% more hydraulic flow (29.3 L/min / 7.7 gpm) than the Deutz-Fahr AgroStar 6.28 (both pump flow, as stated by the source).
- The Case-Steyr 9115 a is 13% heavier (605 kg / 1,334 lb) than the Deutz-Fahr AgroStar 6.28 (both unladen weight, as stated by the source).
- The Deutz-Fahr AgroStar 6.28 has 67% more forward gears (16 gears) than the Case-Steyr 9115 a (both forward gears, as stated by the source).
- The Deutz-Fahr AgroStar 6.28 offers 750 rpm at the PTO, which the Case-Steyr 9115 a does not (as stated by the sources).
- Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 9115 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the 9115 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 9115”); the AgroStar 6.28: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.
← Every figure for both machines, side by side, with sources