CASE-INTERNATIONAL 685 (DT) or Fiat 65-66 (DT)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for CASE-INTERNATIONAL 685 (DT) and Fiat 65-66 (DT), with the call on each
Question685 (DT)65-66 (DT)Call
Which puts more power through the PTO shaft?43.9 kW (58.9 hp)Traktorenlexikon, “Case-IH 685”44.1 kW (59.1 hp)Traktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 685 (DT) and the 65-66 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 685 (DT) and the 65-66 (DT).
Which pumps more oil for implements?32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiat 65-66/65-66 DT”No figureNo call on hydraulic flow: no figure on record for the 685 (DT).
Which lifts more on the three-point hitch?2,380 kg (5,247 lb)Traktorenlexikon, “Case-IH 685”2,356 kg (5,194 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?2,647 kg (5,836 lb)Traktorenlexikon, “Case-IH 685”2,510 kg (5,534 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?4,200 kg (9,259 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT”No figureNo call on maximum permissible mass: no figure on record for the 685 (DT).
Which has the wider choice of gears?8 to 16Traktorenlexikon, “Case-IH 685”12 to 20Traktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 685 (DT) and the 65-66 (DT).
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Case-IH 685”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Case-IH 685”540/1000 rpmTraktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Case-IH 685”independentTraktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Case-IH 685”Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 65-66/65-66 DT”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1985–19901985–1991EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources