10 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 585 (DT)1985–1990No measured PTO figureTractor twoSAME Minitaurus 601978–1984No measured PTO figure
Which should you choose?
Read our verdict on the 585 (DT) and the Minitaurus 60 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 585 (DT) | Minitaurus 60 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.1 hp | 59.1 hp | — |
| Engine declared | IHC D-206 | SAME DA 1053 P | differs |
| Displacement declared | 3.38 L | 3.12 L | +9% 585 (DT) |
| Maximum torque declared | 162 lb·ft · 220 N·m | 162 lb·ft · 220 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal operated dry Laycock single disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 15.1 gpm · 57.2 L/min | 6.3 gpm · 24.0 L/min | +138% 585 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,639 lb · 2,558 kg | 4,828 lb · 2,190 kg | +17% 585 (DT) |
| Wheelbase declared | 78.0 in · 1,981 mm | 84.3 in · 2,140 mm | +8% Minitaurus 60 |
| Length declared | 141.6 in · 3,597 mm | 137.8 in · 3,500 mm | — |
| Width declared | 73.2 in · 1,859 mm | 73.8–89.6 in · 1,875–2,275 mm | differs |
| Ground clearance declared | — | 16.5 in · 420 mm | — |
| Turning radius, braked declared | 11.7 ft · 3.56 m | 10.2 ft · 3.10 m | +15% 585 (DT) |
| Fuel tank declared | 80.0 qt · 75.7 L | 105.7 qt · 100.0 L | +32% Minitaurus 60 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 585 (DT) sources
- Source: Traktorenlexikon, “Case-IH 585”
- Source: Traktorenlexikon, “Case-IH 3230”
SAME Minitaurus 60 sources
- Source: Traktorenlexikon, “SAME Minitaurus 60”
- Source: Traktorenlexikon, “SAME Taurus 60”