9 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 585 (DT)1985–1990No measured PTO figureTractor twoDeutz-Fahr D 6207 (C)1981–1982No measured PTO figure
Which should you choose?
Read our verdict on the 585 (DT) and the D 6207 (C) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 585 (DT) | D 6207 (C) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.1 hp | 59 hp | — |
| Engine declared | IHC D-206 | KHD F4L 912 | differs |
| Displacement declared | 3.38 L | 3.77 L | +11% D 6207 (C) |
| Maximum torque declared | 162 lb·ft · 220 N·m | 169 lb·ft · 229 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal operated dry Laycock single disc clutch | Independent dry double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 15.1 gpm · 57.2 L/min | 9.3 gpm · 35.3 L/min | +62% 585 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,639 lb · 2,558 kg | 5,578 lb · 2,530 kg | — |
| Maximum permissible mass declared | — | 8,818 lb · 4,000 kg | — |
| Wheelbase declared | 78.0 in · 1,981 mm | 83.7 in · 2,125 mm | +7% D 6207 (C) |
| Length declared | 141.6 in · 3,597 mm | 148.0 in · 3,760 mm | — |
| Width declared | 73.2 in · 1,859 mm | 81.1 in · 2,060 mm | +11% D 6207 (C) |
| Ground clearance declared | — | 20.9 in · 530 mm | — |
| Turning radius, braked declared | 11.7 ft · 3.56 m | 11.9 ft · 3.63 m | — |
| Fuel tank declared | 80.0 qt · 75.7 L | 74.0 qt · 70 L | +8% 585 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 585 (DT) sources
- Source: Traktorenlexikon, “Case-IH 585”
- Source: Traktorenlexikon, “Case-IH 3230”
Deutz-Fahr D 6207 (C) sources
- Source: Traktorenlexikon, “Deutz-Fahr D 6207”
- Source: Traktorenlexikon, “Deutz D 6006”