CASE-INTERNATIONAL 485 (DT) or Renault 55-12 V?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 485 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 55-12 V has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Renault 55-12V suits loader and hydraulic implement work better on this data: 129% (2,020 kg / 4,453 lb) more three-point lift.
  • The CASE-INTERNATIONAL 485 (DT) suits heavy draft work (ploughing, cultivating) better on this data: 27% (508 kg / 1,120 lb) heavier and four-wheel drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for CASE-INTERNATIONAL 485 (DT) and Renault 55-12 V, with the call on each
Question485 (DT)55-12 VCall
Which puts more power through the PTO shaft?38.2 kW (51.2 hp)Traktorenlexikon, “Case-IH 485”38.3 kW (51.4 hp)Traktorenlexikon, “Renault 55-12 V R3235”Not comparableNot comparable on power at the PTO shaft: the 485 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 55-12 V has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 485 (DT) and the 55-12 V.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 485 (DT) and the 55-12 V.
Which pumps more oil for implements?45.7 L/min (12.1 gpm)Traktorenlexikon, “Case-IH 485”42.2 L/min (11.1 gpm)Traktorenlexikon, “Renault 55-12 V R3235”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?1,560 kg (3,439 lb)Traktorenlexikon, “Case-IH 485”3,580 kg (7,893 lb)Traktorenlexikon, “Renault 55-12 V R3235”AheadThe Renault 55-12V has 129% more lift (2,020 kg / 4,453 lb) than the CASE-INTERNATIONAL 485 (DT) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,358 kg (5,199 lb)Traktorenlexikon, “Case-IH 485”1,850 kg (4,079 lb)Traktorenlexikon, “Renault 55-12 V R3235”Ahead (a fact, not an advantage)The CASE-INTERNATIONAL 485 (DT) is 27% heavier (508 kg / 1,120 lb) than the Renault 55-12V (both unladen weight, as stated by the source).
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 485 (DT) and the 55-12 V.
Which has the wider choice of gears?8 to 16Traktorenlexikon, “Case-IH 485”8 to 12Traktorenlexikon, “Renault 55-12 V R3235”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the 485 (DT) and the 55-12 V.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Case-IH 485”30 km/h (18.6 mph)Traktorenlexikon, “Renault 55-12 V R3235”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Case-IH 485”540 rpmTraktorenlexikon, “Renault 55-12 V R3235”AheadThe CASE-INTERNATIONAL 485 (DT) offers 1000 rpm at the PTO, which the Renault 55-12V does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Case-IH 485”—No figureNo call on PTO independence: not stated for the 55-12 V.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Case-IH 485”2WDTraktorenlexikon, “Renault 55-12 V R3235”AheadThe CASE-INTERNATIONAL 485 (DT) is available with four-wheel drive; the Renault 55-12V is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1985–19901986–1999EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Renault 55-12V has 129% more lift (2,020 kg / 4,453 lb) than the CASE-INTERNATIONAL 485 (DT) (both lift at the hitch ends, as stated by the source).
  • The CASE-INTERNATIONAL 485 (DT) is 27% heavier (508 kg / 1,120 lb) than the Renault 55-12V (both unladen weight, as stated by the source).
  • The CASE-INTERNATIONAL 485 (DT) offers 1000 rpm at the PTO, which the Renault 55-12V does not (as stated by the sources).
  • The CASE-INTERNATIONAL 485 (DT) is available with four-wheel drive; the Renault 55-12V is two-wheel drive (as stated by the sources).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 485 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 55-12 V has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources