9 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 485 (DT)1985–1990No measured PTO figureTractor twoHürlimann T-5200 (A)1977–1979No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1985–1990; 1977–1979). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 485 (DT) | T-5200 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 51.2 hp | 51.2 hp | — |
| Engine declared | IHC D-179 | Hürlimann D-110 (T) | differs |
| Displacement declared | 2.93 L | 2.95 L | — |
| Maximum torque declared | 121 lb·ft · 164 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 485 (DT) |
| Clutch declared | pedal-operated dry Laycock single-plate clutch, type 11 inches, designed as driving clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.1 gpm · 45.7 L/min | 9.5 gpm · 36.0 L/min | +27% 485 (DT) |
| Pressure declared | — | 2,702 psi · 186 bar | — |
| Three-point lift, at the coupling points declared | 3,439 lb · 1,560 kg | 5,313 lb · 2,410 kg | +54% T-5200 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1050 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,199 lb · 2,358 kg | 5,269 lb · 2,390 kg | — |
| Wheelbase declared | 79.6 in · 2,022 mm | 83.1 in · 2,110 mm | — |
| Length declared | 139.2 in · 3,535 mm | 135.0 in · 3,430 mm | — |
| Width declared | 72.4–90.6 in · 1,840–2,300 mm | 72.8 in · 1,850 mm | differs |
| Ground clearance declared | 9.3 in · 236 mm | 15.7 in · 400 mm | +69% T-5200 (A) |
| Turning radius, braked declared | 11.1 ft · 3.38 m | 8.9 ft · 2.70 m | +25% 485 (DT) |
| Fuel tank declared | 80.0 qt · 75.7 L | 58.1 qt · 55.0 L | +38% 485 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 485 (DT) sources
- Source: Traktorenlexikon, “Case-IH 485”
- Source: Traktorenlexikon, “IHC 553”
Hürlimann T-5200 (A) sources
- Source: Traktorenlexikon, “Hürlimann T-5200”