7 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4230 (DT)1993–1998No measured PTO figureTractor twoNew Holland TLA 80 (A)2004–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (27%); they were not built in overlapping years (1993–1998; 2004–2008). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 4230 (DT) | TLA 80 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 80.9 hp | 80.9 hp | — |
| Engine declared | IHC D-268 | IVECO-NEF F4CE 0404 C | differs |
| Displacement declared | 4.39 L | 4.49 L | — |
| Maximum torque declared | 213 lb·ft · 289 N·m | 217 lb·ft · 294 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated dry single-disc clutch | Dry LuK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 16.5 gpm · 62.4 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | 3,118 psi · 215 bar | +16% TLA 80 (A) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,658 lb · 3,020 kg | 8,466 lb · 3,840 kg | +27% TLA 80 (A) |
| Maximum permissible mass declared | — | 12,125 lb · 5,500 kg | — |
| Wheelbase declared | 88.7 in · 2,253 mm | 92.2 in · 2,342 mm | — |
| Length declared | 138.2 in · 3,510 mm | 171.7 in · 4,362 mm | +24% TLA 80 (A) |
| Width declared | 81.9 in · 2,080 mm | 78.9 in · 2,005 mm | — |
| Ground clearance declared | — | 14.8 in · 376 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 12.4 ft · 3.77 m | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 111.0 qt · 105.0 L | +7% 4230 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4230 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4230”
New Holland TLA 80 (A) sources
- Source: Traktorenlexikon, “New Holland TL 80 A (2004-2008)”
- Source: Traktorenlexikon, “New Holland TL 70 A (2004-2008)”