7 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4230 (DT)1993–1998No measured PTO figureTractor twoDeutz-Fahr Agrotron 4.851995–1997No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%); the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 4230 (DT) | Agrotron 4.85 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 80.9 hp | 81.0 hp | — |
| Engine declared | IHC D-268 | Deutz BF4M 1012 EC | differs |
| Displacement declared | 4.39 L | 3.19 L | +38% 4230 (DT) |
| Maximum torque declared | 213 lb·ft · 289 N·m | 219 lb·ft · 297 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated dry single-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 17.6 gpm · 66.6 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | — | — |
| Three-point lift, at the coupling points declared | 7,055 lb · 3,200 kg | 13,713 lb · 6,220 kg | +94% Agrotron 4.85 |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,658 lb · 3,020 kg | 8,907 lb · 4,040 kg | +34% Agrotron 4.85 |
| Wheelbase declared | 88.7 in · 2,253 mm | 95.2 in · 2,419 mm | +7% Agrotron 4.85 |
| Length declared | 138.2 in · 3,510 mm | 157.7 in · 4,005 mm | +14% Agrotron 4.85 |
| Width declared | 81.9 in · 2,080 mm | 79.1 in · 2,008 mm | — |
| Ground clearance declared | — | 19.1 in · 485 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | — | — |
| Fuel tank declared | 118.3 qt · 112.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4230 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4230”
Deutz-Fahr Agrotron 4.85 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 4.85”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 100”