Case-IH STX 440 or New Holland T 9050?
Which should you choose?
On performance, every comparable figure that differs favours the New Holland T 9050: power at the PTO shaft and maximum permissible mass.
- The New Holland T 9050 suits PTO-driven implements (mowers, balers, pumps) better on this data: 11% (32.1 kW / 43.0 hp) more power at the PTO shaft.
- The New Holland T 9050 suits road haulage better on this data: 36% (6,494 kg / 14,317 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | STX 440 | T 9050 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 298.8 kW (400.7 hp)Traktorenlexikon, “Case-IH STX 440” | 330.9 kW (443.7 hp)Traktorenlexikon, “New Holland T9050” | AheadThe New Holland T 9050 has 11% more power at the PTO (32.1 kW / 43.0 hp) than the Case-IH STX 440 (both power at the PTO, claimed). |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the STX 440 and the T 9050. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the STX 440 and the T 9050. |
| Which pumps more oil for implements? | 155.2 L/min (41.0 gpm)Traktorenlexikon, “Case-IH STX 440” | 153.7 L/min (40.6 gpm)Traktorenlexikon, “New Holland T9050” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 11,166 kg (24,617 lb)Traktorenlexikon, “Case-IH STX 440” | — | No figureNo call on three-point lift: no figure on record for the T 9050. |
| Which is heavier, for traction? | 17,917 kg (39,500 lb)Traktorenlexikon, “Case-IH STX 440” | 19,892 kg (43,854 lb)Traktorenlexikon, “New Holland T9050” | Ahead (a fact, not an advantage)The New Holland T 9050 is 11% heavier (1,975 kg / 4,354 lb) than the Case-IH STX 440 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 18,000 kg (39,683 lb)Traktorenlexikon, “Case-IH STX 440” | 24,494 kg (54,000 lb)Traktorenlexikon, “New Holland T9050” | AheadThe New Holland T 9050 has 36% higher maximum permissible mass (6,494 kg / 14,317 lb) than the Case-IH STX 440 (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 17Traktorenlexikon, “Case-IH STX 440” | 16Traktorenlexikon, “New Holland T9050” | Sources disagreeNo call on forward gears: sources disagree on the figure for the STX 440. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the STX 440 and the T 9050. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Case-IH STX 440” | 30 km/h (18.6 mph)Traktorenlexikon, “New Holland T9050” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Case-IH STX 440” | 1000 rpmTraktorenlexikon, “New Holland T9050” | Sources disagreeNo call on PTO speeds: sources disagree on the PTO speeds of the STX 440. |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the STX 440 and the T 9050. |
| Which drives on both axles? | 4WD / 4WD, equal wheelsTraktorenlexikon, “Case-IH STX 440”; OECD test report 1957, 2001 | 4WDTraktorenlexikon, “New Holland T9050” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2000–2002 | 2007–2010 | Ahead (a fact, not an advantage)The New Holland T 9050 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The New Holland T 9050 has 11% more power at the PTO (32.1 kW / 43.0 hp) than the Case-IH STX 440 (both power at the PTO, claimed).
- The New Holland T 9050 is 11% heavier (1,975 kg / 4,354 lb) than the Case-IH STX 440 (both unladen weight, as stated by the source).
- The New Holland T 9050 has 36% higher maximum permissible mass (6,494 kg / 14,317 lb) than the Case-IH STX 440 (both maximum permissible mass, as stated by the source).
- The New Holland T 9050 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on drive: every machine is available with four-wheel drive.
- No call on forward gears: sources disagree on the figure for the STX 440.
- No call on PTO speeds: sources disagree on the PTO speeds of the STX 440.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources