Case-IH MX 90 C or Fiat TS 100 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the MX 90 C has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TS 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Case-IH MX 90C suits road haulage better on this data: 30% (1,815 kg / 4,001 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | MX 90 C | TS 100 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 66.2 kW (88.8 hp)Traktorenlexikon, “Case-IH MX90C” | 66.2 kW (88.8 hp)Traktorenlexikon, “Fiatagri TS100” | Not comparableNot comparable on power at the PTO shaft: the MX 90 C has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TS 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the MX 90 C and the TS 100 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the MX 90 C and the TS 100 (DT). |
| Which pumps more oil for implements? | 88.4 L/min (23.4 gpm)Traktorenlexikon, “Case-IH MX90C” | 86.0 L/min (22.7 gpm)Traktorenlexikon, “Fiatagri TS100” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | — | 4,294 kg (9,467 lb)Traktorenlexikon, “Fiatagri TS100” | No figureNo call on three-point lift: no figure on record for the MX 90 C. |
| Which is heavier, for traction? | 5,080 kg (11,199 lb)Traktorenlexikon, “Case-IH MX90C” | 3,929 kg (8,662 lb)Traktorenlexikon, “Fiatagri TS100” | Ahead (a fact, not an advantage)The Case-IH MX 90C is 29% heavier (1,151 kg / 2,538 lb) than the Fiat TS 100 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 7,815 kg (17,229 lb)Traktorenlexikon, “Case-IH MX90C” | 6,000 kg (13,228 lb)Traktorenlexikon, “Fiatagri TS100” | AheadThe Case-IH MX 90C has 30% higher maximum permissible mass (1,815 kg / 4,001 lb) than the Fiat TS 100 (DT) (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 16 to 32Traktorenlexikon, “Case-IH MX90C” | 12 to 24Traktorenlexikon, “Fiatagri TS100” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the MX 90 C and the TS 100 (DT). |
| Which is faster on the road? | 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH MX90C” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri TS100” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Case-IH MX90C” | 540/1000 rpmTraktorenlexikon, “Fiatagri TS100” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Case-IH MX90C” | independentTraktorenlexikon, “Fiatagri TS100” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Case-IH MX90C”; OECD test report 1929, 2000 | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri TS100” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1998–2000 | 1997–2003 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-IH MX 90C is 29% heavier (1,151 kg / 2,538 lb) than the Fiat TS 100 (DT) (both unladen weight, as stated by the source).
- The Case-IH MX 90C has 30% higher maximum permissible mass (1,815 kg / 4,001 lb) than the Fiat TS 100 (DT) (both maximum permissible mass, as stated by the source).
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the MX 90 C has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TS 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift and a creeper range.
← Every figure for both machines, side by side, with sources