15 material differences
Tractor oneCase-IH JX802004–200870.7 hpMeasured at the PTO · OECD Test 2632Tractor twoRenault Ceres 3352000–200471.7 hpMeasured at the PTO · OECD Test 1969
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (31%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
15 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | JX80 | Ceres 335 | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | 70.7 hp | 71.7 hp | — |
| Drawbar power, measured measured | 58.9 hp | 60.9 hp | — |
| Engine | |||
| Engine declared | TTF 8035.25E.313T | John Deere 4045 DRT 51 | differs |
| Displacement declared | 2.93 L | 4.53 L | +54% Ceres 335 |
| Maximum torque declared | 235 lb·ft · 319 N·m | 221 lb·ft · 299.2 N·m | +7% JX80 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated dry LuK single-disc clutch | Dry LuK double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | Load sensing | Constant flow | differs |
| Pump flow declared | 15.2–16.3 gpm · 57.6–61.8 L/min | 13.5 gpm · 51.1 L/min | differs |
| Pressure declared | 1,450–2,103 psi · 100–145 bar | — | — |
| Rear PTO speeds declared | 540E/540/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,199–8,322 lb · 2,812–3,775 kg | 8,113–8,289 lb · 3,680–3,760 kg | differs |
| Maximum permissible mass declared | 11,464 lb · 5,200 kg | 12,919 lb · 5,860 kg | +13% Ceres 335 |
| Wheelbase declared | 88.5–92.2 in · 2,249–2,342 mm | 95.8–97.2 in · 2,433–2,470 mm | differs |
| Length declared | 152.8–158.7 in · 3,880–4,032 mm | 176.4 in · 4,481 mm | differs |
| Width declared | 71.2–102.8 in · 1,808–2,610 mm | 73.2–92.1 in · 1,860–2,340 mm | differs |
| Ground clearance declared | 11.2–17.7 in · 285–450 mm | 16.5–19.3 in · 420–490 mm | differs |
| Turning radius, braked declared | 12.1–17.7 ft · 3.70–5.40 m | 12.5–13.3 ft · 3.80–4.05 m | differs |
| Fuel tank declared | 97.2–121.5 qt · 92.0–115.0 L | 158.5 qt · 150.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH JX80 sources
- Source: OECD test report 2632, 2011
- Source: OECD test report 2633, 2011
- Source: Traktorenlexikon, “Case-IH JX80”
- Source: Traktorenlexikon, “Case-IH JX80U”
Renault Ceres 335 sources
- Source: OECD test report 1969, 2001
- Source: OECD test report 1978, 2002
- Source: Traktorenlexikon, “Renault Ceres 335”