11 material differences · fewer than 12
Tractor oneCase-IH JX802004–200870.7 hpMeasured at the PTO · OECD Test 2632Tractor twoMassey Ferguson MF 4345 (A)2001–2003No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their power is not stated as the same quantity on both; they were not built in overlapping years (2004–2008; 2001–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | JX80 | MF 4345 (A) | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | 70.7 hp | — | — |
| Drawbar power, measured measured | 58.9 hp | — | — |
| Engine | |||
| Engine power, claimed claimed | — | 88.8 hp | — |
| Engine declared | TTF 8035.25E.313T | Perkins 1004.40 Turbo | differs |
| Displacement declared | 2.93 L | 3.99 L | +36% MF 4345 (A) |
| Maximum torque declared | 235 lb·ft · 319 N·m | 258 lb·ft · 350 N·m | +10% MF 4345 (A) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Pedal-operated dry LuK single-disc clutch | Pedal-operated, dry and air-cooled single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 15.2–16.3 gpm · 57.6–61.8 L/min | — | — |
| Pressure declared | 1,450–2,103 psi · 100–145 bar | — | — |
| Rear PTO speeds declared | 540E/540/1000 rpm | 540/1000/540E rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,199–8,322 lb · 2,812–3,775 kg | 7,734 lb · 3,508 kg | differs |
| Maximum permissible mass declared | 11,464 lb · 5,200 kg | 15,102 lb · 6,850 kg | +32% MF 4345 (A) |
| Wheelbase declared | 88.5–92.2 in · 2,249–2,342 mm | 92.5 in · 2,350 mm | — |
| Length declared | 152.8–158.7 in · 3,880–4,032 mm | 157.9 in · 4,010 mm | — |
| Width declared | 71.2–102.8 in · 1,808–2,610 mm | 76.8 in · 1,950 mm | differs |
| Ground clearance declared | 11.2–17.7 in · 285–450 mm | 16.9 in · 430 mm | differs |
| Turning radius, braked declared | 12.1–17.7 ft · 3.70–5.40 m | — | — |
| Fuel tank declared | 97.2–121.5 qt · 92.0–115.0 L | 103.6 qt · 98.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH JX80 sources
- Source: OECD test report 2632, 2011
- Source: OECD test report 2633, 2011
- Source: Traktorenlexikon, “Case-IH JX80”
- Source: Traktorenlexikon, “Case-IH JX80U”
Massey Ferguson MF 4345 (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 4345”