Case-IH JX1100U or Fiat L 95 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the JX1100U: power at the PTO, measured by a laboratory at maximum power (OECD Test 2278); the L 95 (DT): power at the PTO, claimed (Traktorenlexikon, “Fiatagri L95”) — not the same quantity, basis and condition.
- The Case-IH JX1100U suits loader and hydraulic implement work better on this data: 20% (860 kg / 1,896 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | JX1100U | L 95 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 65.7 kW (88.1 hp)OECD Test 2278 | 65.0 kW (87.2 hp)Traktorenlexikon, “Fiatagri L95” | Not comparableNot comparable on power at the PTO shaft: the JX1100U: power at the PTO, measured by a laboratory at maximum power (OECD Test 2278); the L 95 (DT): power at the PTO, claimed (Traktorenlexikon, “Fiatagri L95”) — not the same quantity, basis and condition. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the JX1100U and the L 95 (DT). |
| Which pulls harder at the drawbar? | 52.9 kW (70.9 hp)OECD Test 2278 | — | No figureNo call on drawbar power: no figure on record for the L 95 (DT). |
| Which pumps more oil for implements? | 60.5 L/min (16.0 gpm)Traktorenlexikon, “Case-IH JX1100U” | 60.0 L/min (15.9 gpm)Traktorenlexikon, “Fiatagri L95” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 5,060 kg (11,155 lb)Traktorenlexikon, “Case-IH JX1100U” | 4,200 kg (9,259 lb)Traktorenlexikon, “Fiatagri L95” | AheadThe Case-IH JX1100U has 20% more lift (860 kg / 1,896 lb) than the Fiat L 95 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 3,960 kg (8,730 lb) to 4,125 kg (9,094 lb), varies by configurationTraktorenlexikon, “Case-IH JX1100U” | 3,400 kg (7,496 lb)Traktorenlexikon, “Fiatagri L95” | Ahead (a fact, not an advantage)The Case-IH JX1100U is 16% heavier (560 kg / 1,235 lb) than the Fiat L 95 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 6,200 kg (13,669 lb)Traktorenlexikon, “Case-IH JX1100U” | 6,000 kg (13,228 lb)Traktorenlexikon, “Fiatagri L95” | EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which has the wider choice of gears? | 12OECD test report 2278, 2005 | 12 to 24Traktorenlexikon, “Fiatagri L95” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the JX1100U and the L 95 (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH JX1100U” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri L95” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540E/540/1000 rpmTraktorenlexikon, “Case-IH JX1100U” | 540/540E/1000 rpmTraktorenlexikon, “Fiatagri L95” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the JX1100U and the L 95 (DT). |
| Which drives on both axles? | 4WDOECD test report 2278, 2005; Traktorenlexikon, “Case-IH JX1100U” | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri L95” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2004–2008 | 1996–1998 | Ahead (a fact, not an advantage)The Case-IH JX1100U is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-IH JX1100U has 20% more lift (860 kg / 1,896 lb) than the Fiat L 95 (DT) (both lift at the hitch ends, as stated by the source).
- The Case-IH JX1100U is 16% heavier (560 kg / 1,235 lb) than the Fiat L 95 (DT) (both unladen weight, as stated by the source).
- The Case-IH JX1100U is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the JX1100U: power at the PTO, measured by a laboratory at maximum power (OECD Test 2278); the L 95 (DT): power at the PTO, claimed (Traktorenlexikon, “Fiatagri L95”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources