8 material differences · fewer than 12
Tractor oneCase-IH CX 701998–200062.1 hpMeasured at the PTO · OECD Test 1895Tractor twoMassey Ferguson MF 284 S (A)1983–1989No measured PTO figure
Which should you choose?
Read our verdict on the CX 70 and the MF 284 S (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | CX 70 | MF 284 S (A) | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | 62.1 hp | — | — |
| Drawbar power, measured measured | 55.1 hp | — | — |
| Engine | |||
| Engine power, claimed claimed | — | 69.1 hp | — |
| Engine declared | Perkins 1004-4 HR | Perkins A 4.236 | differs |
| Displacement declared | 4.23 L | 3.87 L | +9% CX 70 |
| Maximum torque declared | 195 lb·ft · 265.0 N·m | 194 lb·ft · 263 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Pedal operated dry single-disc clutch as drive clutch | Pedal-operated, dry and air-cooled double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 14.0 gpm · 53.0 L/min | 8.9 gpm · 33.6 L/min | +58% CX 70 |
| Pressure declared | 2,698 psi · 186 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,022 lb · 3,185 kg | 7,143 lb · 3,240 kg | — |
| Maximum permissible mass declared | 13,228 lb · 6,000 kg | — | — |
| Wheelbase declared | 89.1 in · 2,263 mm | 97.6 in · 2,480 mm | +10% MF 284 S (A) |
| Length declared | 156.7 in · 3,980 mm | 155.5 in · 3,950 mm | — |
| Width declared | 82.7 in · 2,100 mm | 79.0 in · 2,007 mm | — |
| Ground clearance declared | 13.0 in · 330 mm | 15.7 in · 400 mm | +21% MF 284 S (A) |
| Fuel tank declared | 163.8 qt · 155.0 L | 126.8 qt · 120 L | +29% CX 70 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH CX 70 sources
- Source: OECD test report 1895, 2000
- Source: Traktorenlexikon, “Case-IH CX70”
Massey Ferguson MF 284 S (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 284 S”
- Source: Traktorenlexikon, “Massey Ferguson MF 168 & MF 168A”