6 material differences · fewer than 12
Tractor oneCase-IH CS-941995–2003No measured PTO figureTractor twoDeutz-Fahr Agroplus 951997–2005No measured PTO figure
Which should you choose?
Read our verdict on the CS-94 and the Agroplus 95 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | CS-94 | Agroplus 95 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.8 hp | — |
| Engine declared | MWM WD 401.85 | — | — |
| Maximum torque declared | — | 263 lb·ft · 357 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Dry double clutch, pedal-operated drive clutch, hand lever-operated PTO clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 14.1 gpm · 53.3 L/min | — | — |
| Rear PTO speeds declared | 390/540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,609 lb · 3,905 kg | 8,378 lb · 3,800 kg | — |
| Maximum permissible mass declared | 14,330 lb · 6,500 kg | 13,669 lb · 6,200 kg | — |
| Wheelbase declared | 97.5 in · 2,477 mm | 92.1 in · 2,340 mm | +6% CS-94 |
| Length declared | 165.7 in · 4,210 mm | 146.2 in · 3,714 mm | +13% CS-94 |
| Width declared | 86.6 in · 2,200 mm | 81.1 in · 2,060 mm | +7% CS-94 |
| Ground clearance declared | 17.7 in · 450 mm | 18.6 in · 472 mm | — |
| Turning radius, braked declared | 15.7 ft · 4.80 m | — | — |
| Fuel tank declared | 105.7 qt · 100.0 L | 147.9 qt · 140 L | +40% Agroplus 95 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH CS-94 sources
- Source: Traktorenlexikon, “Case-IH CS94”
Deutz-Fahr Agroplus 95 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 95”