5 material differences · fewer than 12
Tractor oneCase-IH CS-941995–2003No measured PTO figureTractor twoCase-Steyr M 9094 a1994–2003No measured PTO figure
Which should you choose?
Read our verdict on the CS-94 and the M 9094 a → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 9 fields identical or within 5%, which is not counted as material
| Field | CS-94 | M 9094 a | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.8 hp | — |
| Engine declared | MWM WD 401.85 | Steyr-MWM WD 401.85 | differs |
| Displacement declared | — | 4.16 L | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Dry double clutch, pedal-operated drive clutch, hand lever-operated PTO clutch | Dry Fichtel & Sachs double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 14.1 gpm · 53.3 L/min | 12.7 gpm · 48.1 L/min | +11% CS-94 |
| Rear PTO speeds declared | 390/540/1000 rpm | 430/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,609 lb · 3,905 kg | 8,708 lb · 3,950 kg | — |
| Maximum permissible mass declared | 14,330 lb · 6,500 kg | 14,330 lb · 6,500 kg | — |
| Wheelbase declared | 97.5 in · 2,477 mm | 97.7 in · 2,481 mm | — |
| Length declared | 165.7 in · 4,210 mm | 165.9 in · 4,215 mm | — |
| Width declared | 86.6 in · 2,200 mm | 85.4 in · 2,170 mm | — |
| Ground clearance declared | 17.7 in · 450 mm | 17.3 in · 440 mm | — |
| Turning radius, braked declared | 15.7 ft · 4.80 m | 14.1 ft · 4.30 m | +12% CS-94 |
| Fuel tank declared | 105.7 qt · 100.0 L | 105.7 qt · 100.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH CS-94 sources
- Source: Traktorenlexikon, “Case-IH CS94”
Case-Steyr M 9094 a sources
- Source: Traktorenlexikon, “Steyr M 9094 a”
- Source: Traktorenlexikon, “Steyr 9094”