9 material differences · fewer than 12
Tractor oneCase-IH CS-58 (A)1996–2001No measured PTO figureTractor twoDEUTZ-ALLIS 62601986–1990No measured PTO figure
Which should you choose?
Read our verdict on the CS-58 (A) and the 6260 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | CS-58 (A) | 6260 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.3 hp | 57.3 hp | — |
| Engine declared | PERKINS 903-27 T | KHD F3L 913 | differs |
| Displacement declared | 2.70 L | 3.06 L | +13% 6260 |
| Maximum torque declared | 155 lb·ft · 210 N·m | 144 lb·ft · 195 N·m | +8% CS-58 (A) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Dry Carraro double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 8.1 gpm · 30.8 L/min | 12.5 gpm · 47.5 L/min | +54% 6260 |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,203 lb · 2,360 kg | 6,460 lb · 2,930 kg | +24% 6260 |
| Maximum permissible mass declared | 9,259 lb · 4,200 kg | 11,023 lb · 5,000 kg | +19% 6260 |
| Wheelbase declared | 83.3 in · 2,117 mm | 79.2 in · 2,012 mm | — |
| Length declared | 139.0 in · 3,530 mm | 143.3 in · 3,640 mm | — |
| Width declared | 74.4 in · 1,890 mm | 84.2 in · 2,139 mm | +13% 6260 |
| Ground clearance declared | 16.1 in · 410 mm | 18.0 in · 457 mm | +11% 6260 |
| Turning radius, braked declared | — | 11.8 ft · 3.60 m | — |
| Fuel tank declared | 77.1 qt · 73.0 L | 79.3 qt · 75.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH CS-58 (A) sources
- Source: Traktorenlexikon, “Case-IH CS58/a”
- Source: Traktorenlexikon, “Case-IH CS52/a”
DEUTZ-ALLIS 6260 sources
- Source: Traktorenlexikon, “Deutz-Allis 6260”
- Source: Traktorenlexikon, “Fendt Farmer 260 S/SA”