5 material differences · fewer than 12
Tractor oneCase-IH Magnum 2802005–2011No measured PTO figureTractor twoNew Holland T 80302006–2011No measured PTO figure
Which should you choose?
Read our verdict on the Magnum 280 and the T 8030 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Magnum 280 | T 8030 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 275 hp | 269.3 hp | — |
| Engine declared | — | CUMMINS 6 TAA-8304 (TIER-III) | — |
| Displacement declared | — | 8.27 L | — |
| Maximum torque declared | 949 lb·ft · 1,287 N·m | 861 lb·ft · 1,167 N·m | +10% Magnum 280 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | — | Electro-hydraulically operated wet multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 43.9 gpm · 166 L/min | 44.0 gpm · 166.6 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | 3,336 psi · 230 bar | +10% T 8030 |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 28,440 lb · 12,900 kg | 21,711 lb · 9,848 kg | +31% Magnum 280 |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 118.5 in · 3,010 mm | 121.2 in · 3,078 mm | — |
| Length declared | 234.3 in · 5,950 mm | 229.5 in · 5,829 mm | — |
| Width declared | — | 98.0 in · 2,490 mm | — |
| Ground clearance declared | — | 14.6 in · 372 mm | — |
| Fuel tank declared | — | 720.7 qt · 682.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH Magnum 280 sources
- Source: Traktorenlexikon, “Case-IH Magnum 280”
- Source: OECD test report 2979, 2016
New Holland T 8030 sources
- Source: Traktorenlexikon, “New Holland T8030”
- Source: Traktorenlexikon, “New Holland T8040”