5 material differences · fewer than 12
Tractor oneCase-IH 8331981–1990No measured PTO figureTractor twoInternational Harvester 743XL1981–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 833 | 743XL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66 hp | 66 hp | — |
| Engine declared | Fabrikat IH D- 239 | IH D-239 | differs |
| Displacement declared | 3.91 L | 3.91 L | — |
| Maximum torque declared | 173 lb·ft · 235 N·m | 173 lb·ft · 235 N·m | — |
| Transmission | |||
| Top speed declared | 19.9–24.9 mph · 32–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | dry double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 8.6 gpm · 32.6 L/min | — |
| Pressure declared | 2,393 psi · 165 bar | — | — |
| Rear PTO speeds declared | — | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,688–6,856 lb · 2,580–3,110 kg | 7,187–7,562 lb · 3,260–3,430 kg | differs |
| Maximum permissible mass declared | — | 12,125 lb · 5,500 kg | — |
| Wheelbase declared | 84.6 in · 2,150 mm | 87.6 in · 2,226 mm | — |
| Length declared | 140.6 in · 3,570 mm | 146.9 in · 3,730 mm | — |
| Width declared | — | 80.7 in · 2,050 mm | — |
| Ground clearance declared | 13.6 in · 345 mm | 18.0 in · 457 mm | +32% 743XL |
| Turning radius, braked declared | 12.9 ft · 3.92 m | 12.1 ft · 3.70 m | +6% 833 |
| Fuel tank declared | — | 112.0 qt · 106 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 833 sources
- Source: Traktorenlexikon, “Case-IH 833”
International Harvester 743XL sources
- Source: Traktorenlexikon, “IHC 743XL”
- Source: Traktorenlexikon, “IHC 743”