6 material differences · fewer than 12
Tractor oneCase-IH 8331981–1990No measured PTO figureTractor twoDeutz-Fahr D 6807 (C)1981–1982No measured PTO figure
Which should you choose?
Read our verdict on the 833 and the D 6807 (C) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 833 | D 6807 (C) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66 hp | 66 hp | — |
| Engine declared | Fabrikat IH D- 239 | KHD F4L 912 | differs |
| Displacement declared | 3.91 L | 3.77 L | — |
| Maximum torque declared | 173 lb·ft · 235 N·m | 176 lb·ft · 238 N·m | — |
| Transmission | |||
| Top speed declared | 19.9–24.9 mph · 32–40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 11.1 gpm · 42.0 L/min | — |
| Pressure declared | 2,393 psi · 165 bar | — | — |
| Rear PTO speeds declared | — | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,688–6,856 lb · 2,580–3,110 kg | 6,305 lb · 2,860 kg | differs |
| Maximum permissible mass declared | — | 11,023 lb · 5,000 kg | — |
| Wheelbase declared | 84.6 in · 2,150 mm | 85.4 in · 2,170 mm | — |
| Length declared | 140.6 in · 3,570 mm | 148.0 in · 3,760 mm | +5% D 6807 (C) |
| Width declared | — | 78.3 in · 1,990 mm | — |
| Ground clearance declared | 13.6 in · 345 mm | 18.9 in · 480 mm | +39% D 6807 (C) |
| Turning radius, braked declared | 12.9 ft · 3.92 m | 11.9 ft · 3.62 m | +8% 833 |
| Fuel tank declared | — | 97.2 qt · 92 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 833 sources
- Source: Traktorenlexikon, “Case-IH 833”
Deutz-Fahr D 6807 (C) sources
- Source: Traktorenlexikon, “Deutz-Fahr D 6807”
- Source: Traktorenlexikon, “Deutz D 6006”