11 material differences · fewer than 12
Tractor oneCase-IH C 701992–1997No measured PTO figureTractor twoFiat 70-86 (DT)1992–2000No measured PTO figure
Which should you choose?
Read our verdict on the C 70 and the 70-86 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | C 70 | 70-86 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | Steyr WD 301.87 | FIAT-IVECO 8045.06.208 (309) | differs |
| Displacement declared | 3.12 L | 3.61 L | +16% 70-86 (DT) |
| Maximum torque declared | 198 lb·ft · 268 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Dry Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 11.5 gpm · 43.5 L/min | 10.6 gpm · 40.0 L/min | +9% C 70 |
| Pressure declared | 3,481 psi · 240 bar | 3,118 psi · 215 bar | +12% C 70 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,746 lb · 3,060 kg | 4,292 lb · 1,947 kg | +57% C 70 |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 87.8 in · 2,229 mm | 77.1 in · 1,959 mm | +14% C 70 |
| Length declared | 149.8 in · 3,805 mm | 133.5 in · 3,390 mm | +12% C 70 |
| Width declared | 76.6 in · 1,945 mm | 60.6 in · 1,540 mm | +26% C 70 |
| Ground clearance declared | 15.4 in · 390 mm | 15.0 in · 380 mm | — |
| Fuel tank declared | 66.6 qt · 63.0 L | 47.6 qt · 45.0 L | +40% C 70 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH C 70 sources
- Source: Traktorenlexikon, “Case-IH C70”
Fiat 70-86 (DT) sources
- Source: Traktorenlexikon, “Fiatagri 70-86 V/70-86 V/DT”