Case-IH C-42 (A) or Ford 2610?
Which should you choose?
On performance, every comparable figure that differs favours the Case-IH C-42 (A): three-point lift. It is also ahead on forward gears, PTO speeds and drive.
- The Case-IH C-42 (A) suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 1000 rpm.
- The Case-IH C-42 (A) suits loader and hydraulic implement work better on this data: 29% (407 kg / 897 lb) more three-point lift.
- The Case-IH C-42 (A) suits heavy draft work (ploughing, cultivating) better on this data: 31% (561 kg / 1,237 lb) heavier and four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | C-42 (A) | 2610 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 26.6 kW (35.7 hp)Traktorenlexikon, “Case-IH C42” | 26.9 kW (36.1 hp)Traktorenlexikon, “Ford 2610” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the C-42 (A) and the 2610. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the C-42 (A) and the 2610. |
| Which pumps more oil for implements? | — | 21.8 L/min (5.8 gpm)Traktorenlexikon, “Ford 2610” | No figureNo call on hydraulic flow: no figure on record for the C-42 (A). |
| Which lifts more on the three-point hitch? | 1,820 kg (4,012 lb)Traktorenlexikon, “Case-IH C42” | 1,413 kg (3,115 lb)Traktorenlexikon, “Ford 2610” | AheadThe Case-IH C-42 (A) has 29% more lift (407 kg / 897 lb) than the Ford 2610 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,365 kg (5,214 lb)Traktorenlexikon, “Case-IH C42” | 1,804 kg (3,977 lb)Traktorenlexikon, “Ford 2610” | Ahead (a fact, not an advantage)The Case-IH C-42 (A) is 31% heavier (561 kg / 1,237 lb) than the Ford 2610 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 3,500 kg (7,716 lb)Traktorenlexikon, “Case-IH C42” | — | No figureNo call on maximum permissible mass: no figure on record for the 2610. |
| Which has the wider choice of gears? | 16Traktorenlexikon, “Case-IH C42” | 8Traktorenlexikon, “Ford 2610” | AheadThe Case-IH C-42 (A) has 100% more forward gears (8 gears) than the Ford 2610 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the C-42 (A) and the 2610. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH C42” | 29 km/h (18.0 mph)Traktorenlexikon, “Ford 2610” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Case-IH C42” | 540 rpmTraktorenlexikon, “Ford 2610” | AheadThe Case-IH C-42 (A) offers 1000 rpm at the PTO, which the Ford 2610 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the C-42 (A) and the 2610. |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “Case-IH C42” | 2WDTraktorenlexikon, “Ford 2610” | AheadThe Case-IH C-42 (A) is available with four-wheel drive; the Ford 2610 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1992–1996 | 1981–1983 | Ahead (a fact, not an advantage)The Case-IH C-42 (A) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-IH C-42 (A) has 29% more lift (407 kg / 897 lb) than the Ford 2610 (both lift at the hitch ends, as stated by the source).
- The Case-IH C-42 (A) is 31% heavier (561 kg / 1,237 lb) than the Ford 2610 (both unladen weight, as stated by the source).
- The Case-IH C-42 (A) has 100% more forward gears (8 gears) than the Ford 2610 (both forward gears, as stated by the source).
- The Case-IH C-42 (A) offers 1000 rpm at the PTO, which the Ford 2610 does not (as stated by the sources).
- The Case-IH C-42 (A) is available with four-wheel drive; the Ford 2610 is two-wheel drive (as stated by the sources).
- The Case-IH C-42 (A) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources