8 material differences · fewer than 12
Tractor oneCase-IH C-42 (A)1992–1996No measured PTO figureTractor twoDeutz-Fahr Agrokid 45 A1996–2004No measured PTO figure
Which should you choose?
Read our verdict on the C-42 (A) and the Agrokid 45 A → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | C-42 (A) | Agrokid 45 A | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | Steyr WD 308.48 | Mitsubishi K4F-D (ab 9/2000: S4L-61 ST) | differs |
| Displacement declared | 2.36 L | — | — |
| Maximum torque declared | 108 lb·ft · 147 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 16.8 mph · 27 km/h | differs |
| Clutch declared | — | Mechanically operated dry SAME double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,214 lb · 2,365 kg | 2,227–2,535 lb · 1,010–1,150 kg | differs |
| Maximum permissible mass declared | 7,716 lb · 3,500 kg | 5,291 lb · 2,400 kg | +46% C-42 (A) |
| Wheelbase declared | 77.5 in · 1,968 mm | 66.9 in · 1,700 mm | +16% C-42 (A) |
| Length declared | 129.9 in · 3,300 mm | 118.1 in · 3,000 mm | +10% C-42 (A) |
| Width declared | 73.6 in · 1,870 mm | 48.0–65.2 in · 1,220–1,655 mm | differs |
| Ground clearance declared | 18.1 in · 460 mm | 11.4 in · 290 mm | +59% C-42 (A) |
| Turning radius, braked declared | 10.8 ft · 3.28 m | — | — |
| Fuel tank declared | 56.0 qt · 53.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH C-42 (A) sources
- Source: Traktorenlexikon, “Case-IH C42”
- Source: Traktorenlexikon, “Steyr 942”
Deutz-Fahr Agrokid 45 A sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrokid 45”
- Source: Traktorenlexikon, “Deutz-Fahr Agrokid 35”