Case-IH 9350 or New Holland TJ-330?

Which should you choose?

On performance, every comparable figure that differs favours the New Holland TJ-330: hydraulic flow.

  • The New Holland TJ-330 suits loader and hydraulic implement work better on this data: 49% (50.7 L/min / 13.4 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Case-IH 9350 and New Holland TJ-330, with the call on each
Question9350TJ-330Call
Which puts more power through the PTO shaft?206.6 kW (277.1 hp)Traktorenlexikon, “Case-IH 9350”213.1 kW (285.8 hp)Traktorenlexikon, “New Holland TJ330”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 9350 and the TJ-330.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 9350 and the TJ-330.
Which pumps more oil for implements?103.0 L/min (27.2 gpm)Traktorenlexikon, “Case-IH 9350”153.7 L/min (40.6 gpm)Traktorenlexikon, “New Holland TJ330”AheadThe New Holland TJ-330 has 49% more hydraulic flow (50.7 L/min / 13.4 gpm) than the Case-IH 9350 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?7,189 kg (15,849 lb)Traktorenlexikon, “Case-IH 9350”7,109 kg (15,673 lb)Traktorenlexikon, “New Holland TJ330”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?13,028 kg (28,722 lb)Traktorenlexikon, “Case-IH 9350”14,649 kg (32,296 lb)Traktorenlexikon, “New Holland TJ330”Ahead (a fact, not an advantage)The New Holland TJ-330 is 12% heavier (1,621 kg / 3,574 lb) than the Case-IH 9350 (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 9350 and the TJ-330.
Which has the wider choice of gears?12 to 24Traktorenlexikon, “Case-IH 9350”16 to 24Traktorenlexikon, “New Holland TJ330”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?YesTraktorenlexikon, “New Holland TJ330”No figureNo call on a creeper range: not stated for the 9350.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Case-IH 9350”30 km/h (18.6 mph)Traktorenlexikon, “New Holland TJ330”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?1000 rpmTraktorenlexikon, “Case-IH 9350”1000 rpmTraktorenlexikon, “New Holland TJ330”EvenEven on PTO speeds: the same speeds (1000 rpm).
Which PTO runs independently of the ground drive?No figureNo call on PTO independence: not stated for the 9350 and the TJ-330.
Which drives on both axles?4WDTraktorenlexikon, “Case-IH 9350”4WDTraktorenlexikon, “New Holland TJ330”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1995–20002001–2002Ahead (a fact, not an advantage)The New Holland TJ-330 is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The New Holland TJ-330 has 49% more hydraulic flow (50.7 L/min / 13.4 gpm) than the Case-IH 9350 (both pump flow, as stated by the source).
  • The New Holland TJ-330 is 12% heavier (1,621 kg / 3,574 lb) than the Case-IH 9350 (both unladen weight, as stated by the source).
  • The New Holland TJ-330 is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources