10 material differences · fewer than 12
Tractor oneCase-IH 92401990–1994No measured PTO figureTractor twoJ.I. Case 46941984–1985No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%); they were not built in overlapping years (1990–1994; 1984–1985). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 9240 | 4694 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 231.7 hp | 232.8 hp | — |
| Engine declared | CUMMINS 6 TA-830 | CASE A-504 BDTL | differs |
| Displacement declared | 8.27 L | 8.26 L | — |
| Maximum torque declared | 603 lb·ft · 818 N·m | 680 lb·ft · 922 N·m | +13% 4694 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | F.T.K. multi-plate clutch running in oil bath | Hydraulically operated wet disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 29.1 gpm · 110.2 L/min | 15.5 gpm · 58.7 L/min | +88% 9240 |
| Pressure declared | 3,002 psi · 207 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 28,215 lb · 12,798 kg | 22,311 lb · 10,120 kg | +26% 9240 |
| Wheelbase declared | 124.0 in · 3,150 mm | 102.0 in · 2,591 mm | +22% 9240 |
| Length declared | 256.6 in · 6,517 mm | 225.0 in · 5,715 mm | +14% 9240 |
| Width declared | 104.8–162.0 in · 2,661–4,115 mm | 96.0 in · 2,438 mm | differs |
| Ground clearance declared | 13.4 in · 340 mm | 18.5 in · 470 mm | +38% 4694 |
| Fuel tank declared | 799.9 qt · 757.0 L | 512.5 qt · 485.0 L | +56% 9240 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 9240 sources
- Source: Traktorenlexikon, “Case-IH 9240”
- Source: Traktorenlexikon, “Case-IH 7230 PRO/8930”
J.I. Case 4694 sources
- Source: Traktorenlexikon, “Case 4694”
- Source: Traktorenlexikon, “Case 4690”