9 material differences · fewer than 12
Tractor oneCase-IH 5220 (DT)1989–1997No measured PTO figureTractor twoCase-IH CS-941995–2003No measured PTO figure
Which should you choose?
Read our verdict on the 5220 (DT) and the CS-94 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 5220 (DT) | CS-94 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.7 hp | — |
| Engine declared | CUMMINS NCE 4 T-390 | MWM WD 401.85 | differs |
| Displacement declared | 3.92 L | — | — |
| Maximum torque declared | 237 lb·ft · 321 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry double clutch, pedal-operated drive clutch, hand lever-operated PTO clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 19.6 gpm · 74.3 L/min | 14.1 gpm · 53.3 L/min | +39% 5220 (DT) |
| Pressure declared | 3,191 psi · 220 bar | — | — |
| Rear PTO speeds declared | 635/1000 rpm | 390/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,818 lb · 4,000 kg | 8,609 lb · 3,905 kg | — |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | 14,330 lb · 6,500 kg | +15% 5220 (DT) |
| Wheelbase declared | 107.5 in · 2,730 mm | 97.5 in · 2,477 mm | +10% 5220 (DT) |
| Length declared | 163.0 in · 4,140 mm | 165.7 in · 4,210 mm | — |
| Width declared | 79.7 in · 2,025 mm | 86.6 in · 2,200 mm | +9% CS-94 |
| Ground clearance declared | 22.1 in · 561 mm | 17.7 in · 450 mm | +25% 5220 (DT) |
| Turning radius, braked declared | — | 15.7 ft · 4.80 m | — |
| Fuel tank declared | 179.6 qt · 170.0 L | 105.7 qt · 100.0 L | +70% 5220 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 5220 (DT) sources
- Source: Traktorenlexikon, “Case-IH 5220”
Case-IH CS-94 sources
- Source: Traktorenlexikon, “Case-IH CS94”