10 material differences · fewer than 12
Tractor oneCase-IH 5140 Maxxum1989–1997No measured PTO figureTractor twoFord 8240 (A)1991–1997No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 5140 Maxxum | 8240 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 108.5 hp | 108.5 hp | — |
| Engine declared | CUMMINS NCE 6 T-590 | FORD-POWERSTAR TA 456 CID-NA | differs |
| Displacement declared | 5.88 L | 7.48 L | +27% 8240 (A) |
| Maximum torque declared | 315 lb·ft · 427 N·m | 322 lb·ft · 436 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 19.2 gpm · 72.6 L/min | 21.1 gpm · 80.0 L/min | +10% 8240 (A) |
| Pressure declared | 3,191 psi · 220 bar | 2,582 psi · 178 bar | +24% 5140 Maxxum |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,114 lb · 5,495 kg | 9,824 lb · 4,456 kg | +23% 5140 Maxxum |
| Maximum permissible mass declared | 17,196 lb · 7,800 kg | — | — |
| Wheelbase declared | 101.8 in · 2,585 mm | 105.9 in · 2,690 mm | — |
| Length declared | 175.3 in · 4,453 mm | 171.7 in · 4,361 mm | — |
| Width declared | 86.8 in · 2,204 mm | 82.5–107.6 in · 2,095–2,733 mm | differs |
| Ground clearance declared | 18.3 in · 465 mm | 26.4 in · 670 mm | +44% 8240 (A) |
| Fuel tank declared | 142.7 qt · 135.0 L | 240.0 qt · 227.1 L | +68% 8240 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 5140 Maxxum sources
- Source: Traktorenlexikon, “Case-IH 5140”
Ford 8240 (A) sources
- Source: Traktorenlexikon, “Ford 8240”