7 material differences · fewer than 12
Tractor oneCase-IH 2140 E/V (A)1989–2000No measured PTO figureTractor twoLandini R-6860 (DT) TL-21 N/K (TL-21 DT/K)1988–2000No measured PTO figure
Which should you choose?
Read our verdict on the 2140 E/V (A) and the R-6860 (DT) TL-21 N/K (TL-21 DT/K) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 2140 E/V (A) | R-6860 (DT) TL-21 N/K (TL-21 DT/K) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | SAME 1000.4 A/65 | Perkins LD 4.236 | differs |
| Displacement declared | 4.00 L | 3.87 L | — |
| Maximum torque declared | 172 lb·ft · 233 N·m | 181 lb·ft · 246 N·m | +6% R-6860 (DT) TL-21 N/K (TL-21 DT/K) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Dry, air-cooled LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 10.1 gpm · 38.4 L/min | — |
| Pressure declared | — | 2,756 psi · 190 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,619 lb · 2,095 kg | 5,490 lb · 2,490 kg | +19% R-6860 (DT) TL-21 N/K (TL-21 DT/K) |
| Wheelbase declared | 83.1 in · 2,110 mm | 88.5 in · 2,249 mm | +7% R-6860 (DT) TL-21 N/K (TL-21 DT/K) |
| Length declared | 141.5 in · 3,594 mm | 143.7 in · 3,650 mm | — |
| Width declared | 54.0–78.5 in · 1,371–1,995 mm | 75.4 in · 1,915 mm | differs |
| Ground clearance declared | 14.4 in · 366 mm | 19.1 in · 485 mm | +33% R-6860 (DT) TL-21 N/K (TL-21 DT/K) |
| Turning radius, braked declared | — | 12.6 ft · 3.83 m | — |
| Fuel tank declared | 63.4 qt · 60.0 L | 90.9 qt · 86.0 L | +43% R-6860 (DT) TL-21 N/K (TL-21 DT/K) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 2140 E/V (A) sources
- Source: Traktorenlexikon, “Case-IH 2140”
Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K) sources
- Source: Traktorenlexikon, “Landini 6860”
- Source: Traktorenlexikon, “Massey Ferguson MF 373”