10 material differences · fewer than 12
Tractor oneCase-IH 2140 E/V (A)1989–2000No measured PTO figureTractor twoFord 4830 (A)1990–1992No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (41%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 2140 E/V (A) | 4830 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | SAME 1000.4 A/65 | Ford L 256 CID-NA | differs |
| Displacement declared | 4.00 L | 4.19 L | — |
| Maximum torque declared | 172 lb·ft · 233 N·m | 184 lb·ft · 250 N·m | +7% 4830 (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated dry AP single-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 9.3 gpm · 35.3 L/min | +13% 2140 E/V (A) |
| Pressure declared | — | 1,378–1,450 psi · 95–100 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,619 lb · 2,095 kg | 6,526 lb · 2,960 kg | +41% 4830 (A) |
| Wheelbase declared | 83.1 in · 2,110 mm | 89.6 in · 2,276 mm | +8% 4830 (A) |
| Length declared | 141.5 in · 3,594 mm | 143.7 in · 3,650 mm | — |
| Width declared | 54.0–78.5 in · 1,371–1,995 mm | 69.7–96.7 in · 1,771–2,457 mm | differs |
| Ground clearance declared | 14.4 in · 366 mm | 12.0 in · 305 mm | +20% 2140 E/V (A) |
| Fuel tank declared | 63.4 qt · 60.0 L | 69.4 qt · 65.7 L | +10% 4830 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 2140 E/V (A) sources
- Source: Traktorenlexikon, “Case-IH 2140”
Ford 4830 (A) sources
- Source: Traktorenlexikon, “Ford 4830”