11 material differences · fewer than 12
Tractor oneCase-IH 2140 E/V (A)1989–2000No measured PTO figureTractor twoFiat 65-66 S (DT)1992–1996No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 2140 E/V (A) | 65-66 S (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | SAME 1000.4 A/65 | Fiat 8045.06 | differs |
| Displacement declared | 4.00 L | 3.61 L | +11% 2140 E/V (A) |
| Maximum torque declared | 172 lb·ft · 233 N·m | 159 lb·ft · 216 N·m | +8% 2140 E/V (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 9.1 gpm · 34.5 L/min | +16% 2140 E/V (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,619 lb · 2,095 kg | 6,206 lb · 2,815 kg | +34% 65-66 S (DT) |
| Maximum permissible mass declared | — | 9,259 lb · 4,200 kg | — |
| Wheelbase declared | 83.1 in · 2,110 mm | 89.8 in · 2,280 mm | +8% 65-66 S (DT) |
| Length declared | 141.5 in · 3,594 mm | 147.2 in · 3,740 mm | — |
| Width declared | 54.0–78.5 in · 1,371–1,995 mm | 78.0 in · 1,980 mm | differs |
| Ground clearance declared | 14.4 in · 366 mm | 19.3 in · 490 mm | +34% 65-66 S (DT) |
| Fuel tank declared | 63.4 qt · 60.0 L | 77.1 qt · 73.0 L | +22% 65-66 S (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 2140 E/V (A) sources
- Source: Traktorenlexikon, “Case-IH 2140”
Fiat 65-66 S (DT) sources
- Source: Traktorenlexikon, “Fiatagri 65-66S/65-66 DTS”