8 material differences · fewer than 12
Tractor oneCase-IH 2140 E/V (A)1989–2000No measured PTO figureTractor twoFiat 65-56 LM (DT)from 1988No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1989–2000; 1988–1988). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 2140 E/V (A) | 65-56 LM (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | SAME 1000.4 A/65 | Fiat 8045.06.220 or 320 | differs |
| Displacement declared | 4.00 L | 3.61 L | +11% 2140 E/V (A) |
| Maximum torque declared | 172 lb·ft · 233 N·m | 151 lb·ft · 205 N·m | +14% 2140 E/V (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Dry LuK or VALEO double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 8.7 gpm · 32.8 L/min | +22% 2140 E/V (A) |
| Pressure declared | — | 3,046 psi · 210 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,619 lb · 2,095 kg | 5,004 lb · 2,270 kg | +8% 65-56 LM (DT) |
| Wheelbase declared | 83.1 in · 2,110 mm | 85.3 in · 2,167 mm | — |
| Length declared | 141.5 in · 3,594 mm | 141.7 in · 3,600 mm | — |
| Width declared | 54.0–78.5 in · 1,371–1,995 mm | 71.7–91.3 in · 1,820–2,320 mm | differs |
| Ground clearance declared | 14.4 in · 366 mm | 18.9 in · 480 mm | +31% 65-56 LM (DT) |
| Turning radius, braked declared | — | 11.5 ft · 3.51 m | — |
| Fuel tank declared | 63.4 qt · 60.0 L | 63.4 qt · 60.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 2140 E/V (A) sources
- Source: Traktorenlexikon, “Case-IH 2140”
Fiat 65-56 LM (DT) sources
- Source: Traktorenlexikon, “Fiatagri 65-56 LM (DT)”