8 material differences · fewer than 12
Tractor oneBUKH DZ-301956–1958No measured PTO figureTractor twoInternational Harvester DED (3)1953–1956No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (32%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | DZ-30 | DED (3) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 29.6 hp | 19.7 hp | +50% DZ-30 |
| Engine declared | BUKH 2 EV-100 | IHC DD 99 | differs |
| Displacement declared | 2.04 L | 1.63 L | +25% DZ-30 |
| Maximum torque declared | — | 60 lb·ft · 81 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.9 mph · 20.7 km/h | — |
| Clutch declared | — | Single dry clutch from Fichtel & Sachs | — |
| Hydraulics & hitch | |||
| Pump flow declared | 3.6 gpm · 13.5 L/min | 5.5 gpm · 21.0 L/min | +56% DED (3) |
| Pressure declared | 1,991 psi · 137 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 531 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,571 lb · 1,620 kg | 2,712 lb · 1,230 kg | +32% DZ-30 |
| Wheelbase declared | 71.7 in · 1,820 mm | 66.0 in · 1,676 mm | +9% DZ-30 |
| Length declared | 110.4 in · 2,805 mm | 107.6 in · 2,732 mm | — |
| Width declared | 64.6 in · 1,640 mm | 64.2 in · 1,630 mm | — |
| Ground clearance declared | 17.7 in · 450 mm | 15.6 in · 395 mm | +14% DZ-30 |
| Turning radius, braked declared | 10.2 ft · 3.10 m | 8.7 ft · 2.65 m | +17% DZ-30 |
| Fuel tank declared | 38.0 qt · 36.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BUKH DZ-30 sources
- Source: Traktorenlexikon, “Bukh DZ-30”
International Harvester DED (3) sources
- Source: Traktorenlexikon, “McCormick DED 3”
- Source: Traktorenlexikon, “IHC DED 3”