Bührer OP-17 Standard (A) or International Harvester 504?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Bührer OP-17 Standard (A) is ahead on forward gears, PTO independence and drive; the International Harvester 504 is ahead on top speed.

  • The Bührer OP-17 Standard (A) suits PTO-driven implements (mowers, balers, pumps) better on this data: an independent PTO.
  • The Bührer OP-17 Standard (A) suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
  • The International Harvester 504 suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Bührer OP-17 Standard (A) and International Harvester 504, with the call on each
QuestionOP-17 Standard (A)504Call
Which puts more power through the PTO shaft?32.7 kW (43.9 hp)Traktorenlexikon, “Bührer OP 17 Standard (A)”32.9 kW (44.1 hp)Traktorenlexikon, “IHC 504”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the OP-17 Standard (A) and the 504.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the OP-17 Standard (A) and the 504.
Which pumps more oil for implements?—45.5 L/min (12.0 gpm)Traktorenlexikon, “IHC 504”No figureNo call on hydraulic flow: no figure on record for the OP-17 Standard (A).
Which lifts more on the three-point hitch?1,730 kg (3,814 lb)Traktorenlexikon, “Bührer OP 17 Standard (A)”—No figureNo call on three-point lift: no figure on record for the 504.
Which is heavier, for traction?2,110 kg (4,652 lb)Traktorenlexikon, “Bührer OP 17 Standard (A)”2,022 kg (4,458 lb)Traktorenlexikon, “IHC 504”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the OP-17 Standard (A) and the 504.
Which has the wider choice of gears?15Traktorenlexikon, “Bührer OP 17 Standard (A)”5 to 10Traktorenlexikon, “IHC 504”AheadThe Bührer OP-17 Standard (A) has 50% more forward gears (5 gears) than the International Harvester 504 (both forward gears, as stated by the source).
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the OP-17 Standard (A) and the 504.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Bührer OP 17 Standard (A)”30 km/h (18.6 mph)Traktorenlexikon, “IHC 504”AheadThe International Harvester 504 has 20% more top speed (5.0 km/h / 3.1 mph) than the Bührer OP-17 Standard (A) (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Bührer OP 17 Standard (A)”540 rpmTraktorenlexikon, “IHC 504”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Bührer OP 17 Standard (A)”dependent (stops with the clutch)Traktorenlexikon, “IHC 504”AheadThe Bührer OP-17 Standard (A) has an independent PTO; the International Harvester 504’s is dependent (stops with the clutch).
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Bührer OP 17 Standard (A)”2WDTraktorenlexikon, “IHC 504”AheadThe Bührer OP-17 Standard (A) is available with four-wheel drive; the International Harvester 504 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1969–19751961–1968Ahead (a fact, not an advantage)The Bührer OP-17 Standard (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Bührer OP-17 Standard (A) has 50% more forward gears (5 gears) than the International Harvester 504 (both forward gears, as stated by the source).
  • The International Harvester 504 has 20% more top speed (5.0 km/h / 3.1 mph) than the Bührer OP-17 Standard (A) (both top speed forward, as stated by the source).
  • The Bührer OP-17 Standard (A) has an independent PTO; the International Harvester 504’s is dependent (stops with the clutch).
  • The Bührer OP-17 Standard (A) is available with four-wheel drive; the International Harvester 504 is two-wheel drive (as stated by the sources).
  • The Bührer OP-17 Standard (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources