10 material differences · fewer than 12
Tractor oneBührer Komfort 475 (A)1975–1978No measured PTO figureTractor twoDeutz (KHD) D 70061970–1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1975–1978; 1970–1974). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Komfort 475 (A) | D 7006 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 66 hp | — |
| Engine declared | Perkins A 4.248 | KHD F4L 912 | differs |
| Displacement declared | 4.07 L | 3.77 L | +8% Komfort 475 (A) |
| Maximum torque declared | 195 lb·ft · 265 N·m | 171 lb·ft · 232 N·m | +14% Komfort 475 (A) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 17.1 mph · 27.6 km/h | +10% D 7006 |
| Clutch declared | — | Independent dry Walterscheid double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.7 L/min | — | — |
| Pressure declared | — | 2,538 psi · 175 bar | — |
| Rear PTO speeds declared | 540/800 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,173 lb · 2,800 kg | 6,063 lb · 2,750 kg | — |
| Maximum permissible mass declared | — | 11,023 lb · 5,000 kg | — |
| Wheelbase declared | 84.7 in · 2,152 mm | 94.9 in · 2,410 mm | +12% D 7006 |
| Length declared | 143.7 in · 3,650 mm | 154.9 in · 3,935 mm | +8% D 7006 |
| Width declared | 75.6 in · 1,920 mm | 77.0 in · 1,955 mm | — |
| Ground clearance declared | 16.5 in · 420 mm | 19.9 in · 505 mm | +20% D 7006 |
| Turning radius, braked declared | 11.7 ft · 3.56 m | 13.0 ft · 3.96 m | +11% D 7006 |
| Fuel tank declared | 67.6 qt · 64.0 L | 97.2 qt · 92 L | +44% D 7006 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Bührer Komfort 475 (A) sources
- Source: Traktorenlexikon, “Bührer 475/475A”
- Source: Traktorenlexikon, “Massey Ferguson MF 178”
Deutz (KHD) D 7006 sources
- Source: Traktorenlexikon, “Deutz D 7006”
- Source: Traktorenlexikon, “Deutz D 6006”