Bührer Komfort 465 (A) or Fiat 65-66 (DT)?
Which should you choose?
On performance, every comparable figure that differs favours the Fiat 65-66 (DT): hydraulic flow. It is also ahead on top speed and PTO speeds.
- The Fiat 65-66 (DT) suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 1000 rpm.
- The Fiat 65-66 (DT) suits loader and hydraulic implement work better on this data: 49% (10.8 L/min / 2.9 gpm) more hydraulic flow.
- The Fiat 65-66 (DT) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Komfort 465 (A) | 65-66 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 44.2 kW (59.3 hp)Traktorenlexikon, “Bührer 465/465A” | 44.1 kW (59.1 hp)Traktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Komfort 465 (A) and the 65-66 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Komfort 465 (A) and the 65-66 (DT). |
| Which pumps more oil for implements? | 22.0 L/min (5.8 gpm)Traktorenlexikon, “Bührer 465/465A” | 32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) has 49% more hydraulic flow (10.8 L/min / 2.9 gpm) than the Bührer Komfort 465 (A) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,225 kg (4,905 lb)Traktorenlexikon, “Bührer 465/465A” | 2,356 kg (5,194 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 2,590 kg (5,710 lb)Traktorenlexikon, “Bührer 465/465A” | 2,510 kg (5,534 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | 4,200 kg (9,259 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | No figureNo call on maximum permissible mass: no figure on record for the Komfort 465 (A). |
| Which has the wider choice of gears? | 15Traktorenlexikon, “Bührer 465/465A” | 12 to 20Traktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the Komfort 465 (A) and the 65-66 (DT). |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Bührer 465/465A” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the Bührer Komfort 465 (A) (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Bührer 465/465A” | 540/1000 rpmTraktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) offers 1000 rpm at the PTO, which the Bührer Komfort 465 (A) does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Bührer 465/465A” | independentTraktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “Bührer 465/465A” | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1975–1978 | 1985–1991 | Ahead (a fact, not an advantage)The Fiat 65-66 (DT) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fiat 65-66 (DT) has 49% more hydraulic flow (10.8 L/min / 2.9 gpm) than the Bührer Komfort 465 (A) (both pump flow, as stated by the source).
- The Fiat 65-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the Bührer Komfort 465 (A) (both top speed forward, as stated by the source).
- The Fiat 65-66 (DT) offers 1000 rpm at the PTO, which the Bührer Komfort 465 (A) does not (as stated by the sources).
- The Fiat 65-66 (DT) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources