8 material differences · fewer than 12
Tractor oneBOLINDER-MUNKTELL BM-35/BM-361952–1959No measured PTO figureTractor twoInternational Harvester Farmall MD/MDV1941–1952No measured PTO figure
Which should you choose?
Read our verdict on the BM-35/BM-36 and the Farmall MD/MDV → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | BM-35/BM-36 | Farmall MD/MDV | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 42.0 hp | 34.5 hp | +22% BM-35/BM-36 |
| Engine declared | BOLINDER-MUNKTELL 1053 | INTERNATIONAL HARVESTER D-248 | differs |
| Displacement declared | 3.36 L | 4.06 L | +21% Farmall MD/MDV |
| Maximum torque declared | 152 lb·ft · 206 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 16.2 mph · 26 km/h | +15% BM-35/BM-36 |
| Clutch declared | — | Pedal operated dry Rockford single plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.8 L/min | — | — |
| Pressure declared | 1,276 psi · 88 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 537 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,401 lb · 2,450 kg | 5,300 lb · 2,404 kg | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 90.2 in · 2,292 mm | +17% Farmall MD/MDV |
| Length declared | 124.0 in · 3,150 mm | 126.7 in · 3,219 mm | — |
| Width declared | 66.5 in · 1,690 mm | 84.0–100.0 in · 2,134–2,540 mm | differs |
| Ground clearance declared | 20.7 in · 525 mm | 25.5 in · 648 mm | +23% Farmall MD/MDV |
| Turning radius, braked declared | 11.2 ft · 3.40 m | — | — |
| Fuel tank declared | 68.7 qt · 65.0 L | 84.0 qt · 79.5 L | +22% Farmall MD/MDV |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BOLINDER-MUNKTELL BM-35/BM-36 sources
- Source: Traktorenlexikon, “Bolinder-Munktell BM 35/36”
International Harvester Farmall MD/MDV sources
- Source: Traktorenlexikon, “Farmall Farmall-MD”
- Source: Traktorenlexikon, “McCormick Farmall-MD”
- Source: Traktorenlexikon, “IHC Farmall-MD”