6 material differences · fewer than 12
Tractor oneBOLINDER-MUNKTELL BM-311949–1957No measured PTO figureTractor twoFord 2000 "V" (Dexta)1964–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (72%); they were not built in overlapping years (1949–1957; 1964–1975). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | BM-31 | 2000 "V" (Dexta) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34 hp | 34 hp | — |
| Engine declared | AB-VOLVO D 4 F | — | — |
| Displacement declared | 3.46 L | — | — |
| Maximum torque declared | 134 lb·ft · 182 N·m | 100 lb·ft · 135 N·m | +35% BM-31 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | pedal-operated dry single-disc clutch | dual dry clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.8 L/min | — | — |
| Pressure declared | 1,276 psi · 88 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,060 lb · 2,295 kg | 2,950–6,393 lb · 1,338–2,900 kg | differs |
| Wheelbase declared | 77.2 in · 1,960 mm | 80.0 in · 2,032 mm | — |
| Length declared | 122.6 in · 3,115 mm | 122.0 in · 3,100 mm | — |
| Width declared | 72.4 in · 1,839 mm | 41.5 in · 1,054 mm | +74% BM-31 |
| Ground clearance declared | 16.5 in · 420 mm | 15.6–16.9 in · 395–430 mm | differs |
| Fuel tank declared | 63.4 qt · 60.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BOLINDER-MUNKTELL BM-31 sources
- Source: Traktorenlexikon, “Bolinder-Munktell BM 31”
Ford 2000 "V" (Dexta) sources
- Source: Traktorenlexikon, “Ford 2000 V”