10 material differences · fewer than 12
Tractor oneBOLINDER-MUNKTELL BM-24/BM-251952–1959No measured PTO figureTractor twoHermann Lanz D 28 (TD)1948–1952No measured PTO figure
Which should you choose?
Read our verdict on the BM-24/BM-25 and the D 28 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | BM-24/BM-25 | D 28 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 27.6 hp | 27.5 hp | — |
| Engine declared | VOLVO CF-22 or CB-22 | MWM TD 115 or TD 15 | differs |
| Displacement declared | 2.15 L | 2.85 L | +33% D 28 (TD) |
| Maximum torque declared | — | 116 lb·ft · 157 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | Pedal operated dry single-plate clutch | Single plate dry clutch from Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.8 L/min | — | — |
| Pressure declared | 1,276 psi · 88 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 550 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,459–3,503 lb · 1,569–1,589 kg | 3,858 lb · 1,750 kg | differs |
| Wheelbase declared | 69.7 in · 1,770 mm | 69.3 in · 1,760 mm | — |
| Length declared | 102.2 in · 2,595 mm | 111.4 in · 2,830 mm | +9% D 28 (TD) |
| Width declared | 65.7 in · 1,670 mm | 60.6 in · 1,540 mm | +8% BM-24/BM-25 |
| Ground clearance declared | 16.5 in · 420 mm | 14.8 in · 375 mm | +12% BM-24/BM-25 |
| Turning radius, braked declared | 9.8 ft · 3.00 m | 4.1 ft · 1.25 m | +140% BM-24/BM-25 |
| Fuel tank declared | 47.6 qt · 45.0 L | 39.1 qt · 37 L | +22% BM-24/BM-25 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BOLINDER-MUNKTELL BM-24/BM-25 sources
- Source: Traktorenlexikon, “Bolinder-Munktell BM 24/25”
Hermann Lanz D 28 (TD) sources
- Source: Traktorenlexikon, “HELA D 28 (TD)”