10 material differences · fewer than 12
Tractor oneALLIS-CHALMERS WD-451953–1957No measured PTO figureTractor twoInternational Harvester International 3401958–1963No measured PTO figure
Which should you choose?
Read our verdict on the WD-45 and the International 340 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | WD-45 | International 340 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 37.4 hp | 37.4 hp | — |
| Engine declared | — | INTERNATIONAL HARVESTER C-135 | — |
| Displacement declared | — | 2.21 L | — |
| Maximum torque declared | — | 128 lb·ft · 174 N·m | — |
| Transmission | |||
| Top speed declared | 12.0 mph · 19.3 km/h | 15.5 mph · 25 km/h | +30% International 340 |
| Clutch declared | Foot-operated spring-loaded dry Rockford single-plate clutch | Pedal operated dry Rockford single plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 9.5 gpm · 36.1 L/min | — |
| Rear PTO speeds declared | 548 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,955–4,286 lb · 1,794–1,944 kg | 5,194 lb · 2,356 kg | differs |
| Wheelbase declared | 88.1 in · 2,238 mm | 73.5 in · 1,867 mm | +20% WD-45 |
| Length declared | 127.1 in · 3,228 mm | 117.0 in · 2,972 mm | +9% WD-45 |
| Width declared | 68.0 in · 1,727 mm | 64.0 in · 1,626 mm | +6% WD-45 |
| Ground clearance declared | 21.3 in · 540 mm | 13.0 in · 330 mm | +64% WD-45 |
| Turning radius, braked declared | 4.3 ft · 1.32 m | 12.0 ft · 3.66 m | +177% International 340 |
| Fuel tank declared | 72.1 qt · 68.2 L | 61.3 qt · 58.0 L | +18% WD-45 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS WD-45 sources
- Source: Traktorenlexikon, “Allis-Chalmers WD 45”
International Harvester International 340 sources
- Source: Traktorenlexikon, “IHC 340”
- Source: Traktorenlexikon, “IHC International 330”