5 material differences · fewer than 12

Tractor oneALLIS-CHALMERS FD-41962–1965No measured PTO figureTractor twoSchlüter S 450 (S 450 V)1962–1966No measured PTO figure

Which should you choose?

Read our verdict on the FD-4 and the S 450 (S 450 V) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

5 material differences · 3 fields identical or within 5%, which is not counted as material

ALLIS-CHALMERS FD-4 and Schlüter S 450 (S 450 V), field by field
FieldFD-4S 450 (S 450 V)Gap
Engine
Engine power, claimed claimed41.4 hp41.3 hp—
Engine declaredVENDEUVRE 56——
Maximum torque declared—123 lb·ft · 167 N·m—
Transmission
Top speed declared12.4 mph · 20 km/h12.4–17.4 mph · 20–28 km/hdiffers
Clutch declaredPedal operated dry two stage double clutch——
Hydraulics & hitch
Rear PTO speeds declared540/1000 rpm615/1230 rpmdiffers
Weight & dimensions
Unladen weight declared4,057 lb · 1,840 kg4,960–5,126 lb · 2,250–2,325 kgdiffers
Maximum permissible mass declared—5,071 lb · 2,300 kg—
Wheelbase declared84.6 in · 2,150 mm78.7 in · 2,000 mm+8% FD-4
Length declared120.1 in · 3,050 mm122.6 in · 3,115 mm—
Width declared66.1 in · 1,680 mm63.7 in · 1,618 mm—
Ground clearance declared18.5 in · 470 mm15.0 in · 380 mm+24% FD-4
Turning radius, braked declared—9.8 ft · 3.00 m—
Fuel tank declared63.4 qt · 60.0 L——

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

ALLIS-CHALMERS FD-4 sources

Source
  • Source: Traktorenlexikon, “Allis-Chalmers FD 4”

Schlüter S 450 (S 450 V) sources

Source
  • Source: Traktorenlexikon, “Schlüter S 450 / 450 V”