10 material differences · fewer than 12
Tractor oneALLIS-CHALMERS ED-401960–1968No measured PTO figureTractor twoFahr D 2701954–1958No measured PTO figure
Which should you choose?
Read our verdict on the ED-40 and the D 270 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | ED-40 | D 270 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 36.5 hp | 31.6 hp | +15% ED-40 |
| Engine declared | STANDARD-TRIUMPH 23 C | KHD F2L 514 | differs |
| Displacement declared | 2.26 L | 2.66 L | +18% D 270 |
| Maximum torque declared | 94 lb·ft · 127 N·m | 101 lb·ft · 137 N·m | +8% D 270 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 12.1 mph · 19.4 km/h | +29% ED-40 |
| Hydraulics & hitch | |||
| Pump flow declared | 6.0 gpm · 22.7 L/min | — | — |
| Pressure declared | — | 3,129 psi · 216 bar | — |
| Rear PTO speeds declared | 540 rpm | 572 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,715 lb · 1,685 kg | 4,277 lb · 1,940 kg | +15% D 270 |
| Maximum permissible mass declared | — | 6,856 lb · 3,110 kg | — |
| Wheelbase declared | 76.5 in · 1,943 mm | 78.7 in · 2,000 mm | — |
| Length declared | 121.3 in · 3,080 mm | 120.5 in · 3,060 mm | — |
| Width declared | 71.3–92.9 in · 1,810–2,360 mm | 62.5 in · 1,588 mm | differs |
| Ground clearance declared | 17.6 in · 448 mm | 14.2 in · 360 mm | +24% ED-40 |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 10.0 ft · 3.05 m | +8% ED-40 |
| Fuel tank declared | 56.4–80.8 qt · 53.4–76.5 L | 54.9 qt · 52 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS ED-40 sources
- Source: Traktorenlexikon, “Allis-Chalmers ED 40”
Fahr D 270 sources
- Source: Traktorenlexikon, “Fahr D 270”