6 material differences · fewer than 12

Tractor oneALLIS-CHALMERS D-171957–1967No measured PTO figureTractor twoFord 9601954–1957No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (34%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

6 material differences · 3 fields identical or within 5%, which is not counted as material

ALLIS-CHALMERS D-17 and Ford 960, field by field
FieldD-17960Gap
Engine
Engine power, claimed claimed46.1 hp46.4 hp—
Engine declaredALLIS-CHALMERS G-226——
Transmission
Top speed declared12.4 mph · 20 km/h13.0 mph · 21 km/h—
Clutch declaredFoot-operated spring-loaded dry single-plate Rockford clutch——
Hydraulics & hitch
Pump flow declared10.5 gpm · 39.7 L/min——
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared4,868 lb · 2,208 kg3,627 lb · 1,645 kg+34% D-17
Wheelbase declared93.0–95.7 in · 2,362–2,432 mm85.3 in · 2,167 mmdiffers
Length declared140.0–143.0 in · 3,556–3,632 mm132.6 in · 3,368 mmdiffers
Width declared76.7 in · 1,949 mm64.8–87.5 in · 1,645–2,223 mmdiffers
Ground clearance declared22.8 in · 580 mm27.9 in · 709 mm+22% 960
Fuel tank declared75.9 qt · 71.8 L67.2 qt · 63.6 L+13% D-17

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

ALLIS-CHALMERS D-17 sources

Source
  • Source: Traktorenlexikon, “Allis-Chalmers D 17”

Ford 960 sources

Source
  • Source: Traktorenlexikon, “Ford 900”