8 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 220 Landhandler1969–1973No measured PTO figureTractor twoSteyr 1400 a1974–1979No measured PTO figure
Which should you choose?
Read our verdict on the 220 Landhandler and the 1400 a → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 220 Landhandler | 1400 a | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 136.1 hp | 138 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | Steyr WD-612.85 | differs |
| Displacement declared | 6.97 L | 6.59 L | +6% 220 Landhandler |
| Maximum torque declared | — | 398 lb·ft · 540 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 19.9 mph · 32 km/h | +7% 1400 a |
| Clutch declared | — | dry Fichtel & Sachs single disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | 10.8 gpm · 41.0 L/min | +52% 220 Landhandler |
| Pressure declared | — | 2,489 psi · 172 bar | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,161 lb · 5,516 kg | 12,478 lb · 5,660 kg | — |
| Maximum permissible mass declared | — | 17,637 lb · 8,000 kg | — |
| Wheelbase declared | 100.0 in · 2,539 mm | 106.3 in · 2,700 mm | +6% 1400 a |
| Length declared | 164.0 in · 4,166 mm | 231.9 in · 5,890 mm | +41% 1400 a |
| Width declared | 96.0 in · 2,438 mm | 96.1 in · 2,440 mm | — |
| Ground clearance declared | 21.0 in · 533 mm | 18.9 in · 480 mm | +11% 220 Landhandler |
| Turning radius, braked declared | 11.3 ft · 3.45 m | — | — |
| Fuel tank declared | 203.9 qt · 193.0 L | 262.1 qt · 248.0 L | +28% 1400 a |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 220 Landhandler sources
- Source: Traktorenlexikon, “Allis-Chalmers 220”
- Source: Traktorenlexikon, “Allis-Chalmers 210”
Steyr 1400 a sources
- Source: Traktorenlexikon, “Steyr 1400”