12 material differences
Tractor oneALLIS-CHALMERS 2101970–1972No measured PTO figureTractor twoSchlüter Super 1250 VL1972–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 210 | Super 1250 VL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 123.2 hp | 123 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | Schlüter SDM 110 W6 (ab 1/1985 = SDM 112 W6) | differs |
| Displacement declared | 6.97 L | — | — |
| Maximum torque declared | — | 391 lb·ft · 530 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 21.7–24.9 mph · 35–40 km/h | differs |
| Clutch declared | Pedal or hand-operated dry single-disc clutch | Voith turbo clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | 10.0 gpm · 37.9 L/min | +65% 210 |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,425 lb · 5,636 kg | 11,100–13,448 lb · 5,035–6,100 kg | differs |
| Wheelbase declared | 100.0 in · 2,539 mm | 103.8–110.6 in · 2,637–2,810 mm | differs |
| Length declared | 164.0 in · 4,166 mm | 177.8–187.4 in · 4,515–4,760 mm | differs |
| Width declared | 96.0 in · 2,438 mm | 87.0–98.4 in · 2,210–2,500 mm | differs |
| Ground clearance declared | 21.6 in · 549 mm | 17.7 in · 450 mm | +22% 210 |
| Turning radius, braked declared | 11.3 ft · 3.45 m | 15.1 ft · 4.60 m | +33% Super 1250 VL |
| Fuel tank declared | 203.9 qt · 193.0 L | 327.6 qt · 310 L | +61% Super 1250 VL |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 210 sources
- Source: Traktorenlexikon, “Allis-Chalmers 210”
Schlüter Super 1250 VL sources
- Source: Traktorenlexikon, “Schlüter Super 1250 VL”
- Source: Traktorenlexikon, “Schlüter Super 1250 VL Special”