11 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 2101970–1972No measured PTO figureTractor twoLamborghini R-1306 DT1984–1996No measured PTO figure
Which should you choose?
Read our verdict on the 210 and the R-1306 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 210 | R-1306 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 123.2 hp | 123.2 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | SAME 916.6 WT | differs |
| Displacement declared | 6.97 L | 5.50 L | +27% 210 |
| Maximum torque declared | — | 330 lb·ft · 448 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal or hand-operated dry single-disc clutch | Pedal-operated dry Lamborghini single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | 13.4 gpm · 50.8 L/min | +23% 210 |
| Pressure declared | — | 3,046 psi · 210 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,425 lb · 5,636 kg | 11,244 lb · 5,100 kg | +11% 210 |
| Wheelbase declared | 100.0 in · 2,539 mm | 108.3 in · 2,750 mm | +8% R-1306 DT |
| Length declared | 164.0 in · 4,166 mm | 170.3 in · 4,325 mm | — |
| Width declared | 96.0 in · 2,438 mm | 85.4–105.1 in · 2,170–2,670 mm | differs |
| Ground clearance declared | 21.6 in · 549 mm | 19.7 in · 500 mm | +10% 210 |
| Turning radius, braked declared | 11.3 ft · 3.45 m | — | — |
| Fuel tank declared | 203.9 qt · 193.0 L | 243.0 qt · 230.0 L | +19% R-1306 DT |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 210 sources
- Source: Traktorenlexikon, “Allis-Chalmers 210”
Lamborghini R-1306 DT sources
- Source: Traktorenlexikon, “Lamborghini 1306 DT”