6 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 2101970–1972No measured PTO figureTractor twoJohn Deere 50101962–1966No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1970–1972; 1962–1966). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 210 | 5010 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 123.2 hp | 121 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | Deere 531 CID | differs |
| Displacement declared | 6.97 L | 8.70 L | +25% 5010 |
| Maximum torque declared | — | 339 lb·ft · 459 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 5010 |
| Clutch declared | Pedal or hand-operated dry single-disc clutch | Single-plate dry clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,425 lb · 5,636 kg | 13,400 lb · 6,078 kg | +8% 5010 |
| Wheelbase declared | 100.0 in · 2,539 mm | 103.9 in · 2,640 mm | — |
| Length declared | 164.0 in · 4,166 mm | 172.0 in · 4,370 mm | — |
| Width declared | 96.0 in · 2,438 mm | 95.7 in · 2,430 mm | — |
| Ground clearance declared | 21.6 in · 549 mm | — | — |
| Turning radius, braked declared | 11.3 ft · 3.45 m | — | — |
| Fuel tank declared | 203.9 qt · 193.0 L | 191.3 qt · 181 L | +7% 210 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 210 sources
- Source: Traktorenlexikon, “Allis-Chalmers 210”
John Deere 5010 sources
- Source: Traktorenlexikon, “John Deere 5010”
- Source: Traktorenlexikon, “John Deere 5020”