10 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 2101970–1972No measured PTO figureTractor twoFiat 1280 (DT)1979–1984No measured PTO figure
Which should you choose?
Read our verdict on the 210 and the 1280 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 210 | 1280 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 123.2 hp | 123 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | FIAT-IVECO 8065.24.217 (317) | differs |
| Displacement declared | 6.97 L | 5.50 L | +27% 210 |
| Maximum torque declared | — | 297 lb·ft · 403 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal or hand-operated dry single-disc clutch | Dry FERODO or LuK single-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | 13.4 gpm · 50.6 L/min | +24% 210 |
| Pressure declared | — | 3,263–3,408 psi · 225–235 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,425 lb · 5,636 kg | 12,015 lb · 5,450 kg | — |
| Wheelbase declared | 100.0 in · 2,539 mm | 108.3 in · 2,750 mm | +8% 1280 (DT) |
| Length declared | 164.0 in · 4,166 mm | 164.6 in · 4,182 mm | — |
| Width declared | 96.0 in · 2,438 mm | 92.9 in · 2,360 mm | — |
| Ground clearance declared | 21.6 in · 549 mm | 19.7 in · 500 mm | +10% 210 |
| Turning radius, braked declared | 11.3 ft · 3.45 m | 13.9 ft · 4.25 m | +23% 1280 (DT) |
| Fuel tank declared | 203.9 qt · 193.0 L | 190.2 qt · 180.0 L | +7% 210 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 210 sources
- Source: Traktorenlexikon, “Allis-Chalmers 210”
Fiat 1280 (DT) sources
- Source: Traktorenlexikon, “Fiat 1280 DT”